Safety Acceptance Letter WZ-280

Downloadable Version
PDF [169 KB]

DOT logo
U.S. Department of Transportation
Federal Highway Administration

1200 New Jersey Ave. S.E.
Washington, D.C. 20590

In Reply Refer To: HSSD/WZ-280

Mr. John Reynolds
Chief Engineer
Work Zone Safety Products
14817 Rosetown Ave.
Fontana, CA 92336

Dear Mr. Reynolds:

In your letter of April 10, 2009, you requested the Federal Highway Administration (FHWA) acceptance of the WZ Deluxe Tri-Pod temporary sign stand as a crashworthy traffic control device for use in work zones on the National Highway System (NHS). You requested acceptance of the temporary sign stand for use with the following sign substrate material: 1/2 inch thick plywood, 0.125 inch thick aluminum, 2 mm and 3 mm aluminum laminate, corrugated plastic, and roll-up material. Your request for acceptance is based on the performance of the generic tri-pod sign stand accepted in FHWA letters WZ-240 and a similar tri-pod stand in WZ-207. Accompanying your letter were the FHWA Office of Safety Design forms that included a drawing and a detailed description of the WZ Deluxe Tri-Pod. Drawings of the WZ Deluxe Tri-Pod are enclosed for reference. You requested that we find the WZ Deluxe Tri-Pod acceptable for use as a Test Level 3 device on the NHS under the provisions of the National Cooperative Highway Research Program Report 350 "Recommended Procedures for the Safety Performance Evaluation of Highway Features”.

This letter acknowledges FHWA's acceptance of your request. The original completed forms have been modified by the addition of the FHWA acceptance letter number and the date of our review. The forms will be posted on our Web site in the near future.

 

Sincerely yours,

Signature of George E. Rice, Jr

for David A. Nicol, P.E.
Director, Office of Safety Design
Office of Safety

Enclosures

Program Contact

Cathy Satterfield

708-283-3552

What’s New

Proposed Revision of the 2009 MUTCD – Compliance Dates NEW!

FHWA Technical Advisory T 5040.40: Center Line Rumble Strips NEW!

FHWA Memo: Technical Advisories for Rumble Strips NEW!

Roadway Departure Safety Implementation Plans

Roadway Departure Countermeasures

Roadside Design: Steel Strong Post W-beam. A guidance memo was issued on May 17, 2010 on the height of guardrail for new installations. Guidance regarding existing guardrail will be developed in the next several months, in consultation with AASHTO's Technical Committee on Roadside Safety.

Pavement Marking Retroreflectivity Notice of Proposed Rulemaking [HTML, PDF]

MUTCD Text of the Proposed Pavement Marking Retroreflectivity Standard

Summary of the MUTCD Pavement Marking Retroreflectivity Standard

Revised Assessment of Economic Impacts of Pavement Marking Retroreflectivity

Publications

Low Cost Treatments for Horizontal Curve Safety

The Safety Edge