U.S. Department of Transportation
Federal Highway Administration
1200 New Jersey Avenue, SE
Washington, DC 20590
202-366-4000
U.S. Department of Transportation
Federal Highway Administration
1200 New Jersey Ave. S.E.
Washington, D.C. 20590
SENT VIA ELECTRONIC MAIL
Subject: INFORMATION: FHWA Acceptance Letter B-181 Random Rubble Cavit Wall
Date: July 28, 2008
From: /s/ David A. Nicol, P.E. Director, Office of Safety Design
In Reply Refer To: HSSD/B-181
To: Ms. Victoria Brinkly Highway Safety Engineer (HFL-17) Western Federal Lands Highway Division
This memorandum is in response to your request for FHWA’s acceptance of a roadside safety system for use on the NHS.
Name of system: | Random Rubble Cavity Wall |
---|---|
Type of system: | Aesthetic Stone Faced Concrete Barrier Guardwall |
Test Level: | NCHRP Report 350 TL-1 |
Testing conducted by: | SwRI |
Date of request: | March 10, 2008 |
You requested that we find this system acceptable for use on the NHS under the provisions of the NCHRP Report 350 "Recommended Procedures for the Safety Performance Evaluation of Highway Features."
Requirements
Roadside safety systems should meet the guidelines contained in the NCHRP Report 350, "Recommended Procedures for the Safety Performance Evaluation of Highway Features". The FHWA Memorandum "ACTION: Identifying Acceptable Highway Safety Features"of July 25, 1997 provides further guidance on crash testing requirements of longitudinal barriers
Description
The Random Rubble Cavity Wall is 460 mm wide and composed of two different height sections. One section is 460 mm tall by 3.66 m long, and the other section is 610 mm tall by 1.68 m long as shown in the attached drawings for reference. The sections are staggered such that there is a 610 mm tall section then a 460 mm tall section and then another 610 mm tall section. This alternating height pattern continues for the length of the installation. The guardwall consists of a reinforced concrete footing and a reinforced concrete core. Indigenous rock is placed on the sides and top of the concrete core. The majority of the rock is 300 mm to 460 mm in size with smaller rocks and masonry mortar used to complete the assembly of the guardwall. Crash Testing Full-scale crash testing was conducted on this barrier. The TL-2 testing at 70 km/hr (43.5 mph) resulted in failure when the 2000P test vehicle drove over the barrier. Two TL-1 tests were conducted at 50 km/hr (31 mph), NCHRP Report 350 Test 1-10 (RW-2) and Test 1-11 (RW-1). Copies of the test data summary sheets for these tests are enclosed for reference. In both tests the vehicles were smoothly redirected and the occupant impact values were within the required limits. There was no deflection of the barrier in either test, nor was there any deformation of the occupant compartment.
Findings
Therefore, Random Rubble Cavity Wall described above and detailed in the enclosed drawings is acceptable for use on the NHS under the range of conditions tested, when such use is acceptable to a highway agency.
Please note the following standard provisions that apply to the FHWA letters of acceptance: