December 17, 2008

In Reply Refer To: HSSD/WZ-274

Mr. Ken Mobley
President
Global Sign Products, LLC
Eastman, GA 31023

Dear Mr. Mobley:

In your letter of October 21 you requested the Federal Highway Administration (FHWA) acceptance of Signabond Valu-Lite 2 mm, Valu-Lite 3 mm, and LITE 4 mm sign substrates. Accompanying your letter were product specifications. You requested acceptance of Signabond sign substrates for use with accepted sign stands on the National Highway System (NHS) under the provisions of the National Cooperative Highway Research Program (NCHRP) Report 350 “Recommended Procedures for the Safety Performance Evaluation of Highway Features.”

Upon request, you provided samples of the Signabond sign substrate to the FHWA that were received on November 5. The Signabond sign substrate is a brand name of aluminum laminate material. The material properties of the Valu-Lite 2 mm, Valu-Lite 3 mm, and LITE 4 mm Signabond substrates are nearly identical and considered to be equivalent to other previously accepted 2 mm, 3 mm, and 4 mm aluminum laminate sign substrates. Our records indicate that 2 mm, 3 mm, and 4 mm aluminum laminate signs have been successfully crash tested on portable stands made by a number of manufacturers and are limited to use on the tested and accepted stands. Therefore, the FHWA accepts the use of Signabond Valu-Lite 2 mm, Valu-Lite 3 mm, and LITE 4 mm aluminum laminate sign substrates for use on the NHS under the range of conditions that equivalent materials have been tested and accepted, when proposed by a State.

Please note the following standard provisions that apply to the FHWA letters of acceptance:

• This acceptance is limited to the crashworthiness characteristics of the device and does not cover their structural features, nor conformity with the Manual on Uniform Traffic Control Devices.
• Any changes that may adversely influence the crashworthiness of the device/system will require a new acceptance letter.
• Should the FHWA discover that the qualification testing was flawed, that in-service performance reveals unacceptable safety problems, or that the device/system being marketed is significantly different from the version that was crash tested, we reserve the right to modify or revoke our acceptance.
• You will be expected to supply potential users with sufficient information on design and installation requirements to ensure proper performance.
• You will be expected to certify to potential users that the hardware furnished has essentially the same chemistry, mechanical properties, and geometry as that submitted for acceptance, and that it will meet the crashworthiness requirements of the FHWA and the NCHRP Report 350.
• To prevent misunderstanding by others, this letter of acceptance is designated as number WZ-274 and shall not be reproduced except in full. This letter and the test documentation upon which it is based are public information. All such letters and documentation may be reviewed at our office upon request.
• The Signabond substrates are patented products and considered proprietary. If proprietary devices/systems are specified by a highway agency for use on Federal-aid projects, except exempt, non-NHS projects, they: (a) must be supplied through competitive bidding with equally suitable unpatented items; (b) the highway agency must certify that they are essential for synchronization with the existing highway facilities or that no equally suitable alternative exists; or (c) they must be used for research or for a distinctive type of construction on relatively short sections of road for experimental purposes. Our regulations concerning proprietary products are contained in Title 23, Code of Federal Regulations, Section 635.411.
• This acceptance letter shall not be construed as authorization or consent by the FHWA to use, manufacture, or sell any patented device/system for which the applicant is not the patent holder. The acceptance letter is limited to the crashworthiness characteristics of the candidate device/system, and the FHWA is neither prepared nor required to become involved in issues concerning patent law. Patent issues, if any, are to be resolved by the applicant.

Safety Home | FHWA Home | Feedback